APC Tools & Equipment - 1st Quarter 2020

FRONT-END & SUSPENSION

TIE ROD SERVICE TOOLS

$49. 95 Pitman Arm Puller OTC-7314A

$85. 95 Outer Tie Rod Remover OTC-7503

STK-71470

Tie Rod Coupler • Tough alloy steel coupler with dual I-bolt set screws provide a quick temporary steering repair for vehicles with a broken tie rod. • Tie Rod Coupler I-bolt set screws secures the coupler to the broken tie rod by hand tightening and/or locking down the set screws by using a small leverage bar • The temporary steering fix saves the tow driver up to 15 minutes by ensuring the driver’s ability to center and properly secure the vehicle on the roll back bed as well as maneuvering the vehicle around the lot to the frame bench or repair bay

SLY-11880

Large Pitman Arm Remover • For removing large Pitman arms on 3/4 to 1 ton pickup trucks • Applications: Ford F250/350, Dodge 2500/3500, Chevrolet/GMC 2500/3500

$434. 95 SLY-14900

$45. 95

Sheppard Pitman Arm Remover • Forged Alloy Steel To Remove The Pitman Arm From Sheppard Steering Boxes • Ball Bearing Tip To Protect The Sector Shaft • Designed With A Fine Thread Pitch For Reduced Effort During Service • Removable Nut Attachment For Use On Short And Long Sector Shafts

LAN-615

$484. 58

Tie Rod Wrench • For adjusting tie rods on vehicles with rack and pinion steering • Works on most spline, hex, and two flat design tie rods • Spring-loaded upper jaw pivots to accommodate tie rods ranging in size from 10mm–18mm • Wrench is self-adjusting • Cam action increases the gripping pressure as the load applied to the handle increases • Heat-treated for durability

OTC-6295

Front End Service Set • This kit includes five popular tools used for servicing Pitman arms, ball joints, and tie rods on most vehicles • Set includes: • Two Pitman Arm Pullers for large or small ball joint applications • Two Ball Joint Separators • Three different Tie Rod Pullers

$99. 95

CONTROL ARM SERVICE

$189. 95

OTC-6007

AST-7802

Lower Control Arm Triple Action Tool

Tie Rod/Pitman Arm Adjusting Tool Set • 1 pc Pitman arm tool • 4 pc Tie rod tools • Special tool designfacilites 360º rotationof adjusting sleeve in tight areas • Accommodates 1/2” drive ratchet or breaker bar

Lower Control Arm Prying Tool Installing a ball joint on a lower control arm typically requires the effort of two people. However, with this tool and our No. 7420 or 7421 pry bar – or any 7/8" diameter pry bar – it’s a one-person job. No. 6007 – Lower control arm prying tool.

$59. 95

$20. 95

GW-41610

OTC-7832

Pneumatic Tie Rod / Ball Joint Separator Kit • Works with Hand and Pneumatic Air systems to remove Tie Rods, Ball Joint and Pitman Arm assemblies • Includes most popular sizes 1-1/8, 15/16 and 11/16

GM Torsion Bar Unload • Required to safely release the tension on the front suspension torsion bar to service the front suspension. • Larger design to cover the newer GM truck applications. • Application: 2011 & newer HD C/K trucks.

$49. 95

$179. 95

181

PRICES ARE SUBJECT TO CHANGE AND WILL BE CONFIRMED AT TIME OF ORDER. PLEASE SEE WWW.G2SONLINE.CA/CATALOG FOR UPDATES AND CORRECTIONS.

January 1 to March 31, 2020